48in Acrylic Plastic PVC Bending Machine 125cmHeater Hot Heating Bender Manual Hot Heating Bender Tool Bending Thickness 1-6mm 110V 1500W

SpecificationInput Voltage: Ac 110VHeating Peak: Zw-300 420 ℃, The Other 250 ℃Heating Bending Thickness: 1-6mmHeating Port Width: 8mmEffective Heating Length: 1220 MmPower: 1500WProduct Size：Approx.135*4*4cm/53.1*1.6*1.6inNet Weight:4kgGross Weight: 4.5kgPackage Dimensions (L x W x H): 147*20*12cmPacking List1 X Acrylic Pvc Bending Machine Heater1 X Water Pump2 X Silicone Tubes1 X Temperature Controller1 X Water ThermometerInstruction1. Keep a cooling tank (barrel) of more than 30 liters. First, connect the heater body and the submersible pump with a silicone hose.Place the submersible pump in the cooling bucket, connect the power supply of the pump, and wait for the water to circulate out. (note: the water temperature of the machine will keep rising for a long time. Please replace the cold water clearly.The temperature of the circulating water should not drop abruptly. When the water temperature exceeds 50 degrees, the power supply of the heater should be cut off in time, and the circulating water should be replaced later).2. Connect the thermostat with the hot bender and connect it to 220v power supply. Adjust the knob of the thermostat controller. The clockwise direction is to raise the temperature, and vice versa. When adjusting, it is not appropriate to rotate too fast. 3. When the heating pipe reaches the required temperature, it can place the plastic sheet which needs to be hot-bended on the heating trough. When the sheet is soft enough to be folded manually, it can bend at various angles.

• Temperature adjustable. Product temperature is uniform, water circulation cooling. If bending thick plates, slotting bending, bending angle will be more beautiful, you can adapt to local conditions, flexible use.
• Portable. Light and practical. Space-saving, hot bending of plastic sheets of various materials, such as thickness more than 6 mm. Applicable materials: acrylic, organic board, pvc and various thermoplastic materials.
• Can be heated up and down simultaneously by two heaters. Can be combined with multiple heaters to heat multiple bending points at one time. Can be combined with the worktable into a hot bending machine, can also be used alone.
• There is water circulation cooling on both sides of the heating tube to ensure that there will be no thermal deformation except where heating is needed. Widely used in decoration engineering, sign making, display cabinets, aquarium wrapping, lighting led channel letters, supermarket shelves, curtain walls, large light boxes, etc.
• Power supply and water pipe are connected at both ends respectively. Hydropower separation is intuitive, easy to plug and pull, convenient to collect, and easy to assemble with the workbench.